My Blinkies

To Be Added Soon


Networked Blogs

Enter Block content here...

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Etiam pharetra, tellus sit amet congue vulputate, nisi erat iaculis nibh, vitae feugiat sapien ante eget mauris.

Tuesday, June 5, 2012

Emo Kisses

This tut was made using PSPx4
And knowledge of PSPx4.

Supplies needed
PTU Emotions from Crystals Creations HERE.
Tube of Choice. I am using The Hunter.
You need a lic to use his work. You can get it and his work HERE.
Font Of Choice I used Whimsy TT.You can get it HERE.
Mask of choice. I used MB and SW mask 18 by Moonbeams and Spiderwebs.
You can get it HERE.

When you see ** look at tag to see placement for Elements.
Sometimes it is hard to say just how to place it.
Drop shadows added are unless otherwise stated.

It is always good to check for overhang of shadow on edges of tag.
I have made a tag or to and not check and when I got done
I would post it and see the over hang on the sides and think MAN!! lol

Remember to save often.

Open New Image 600x600

Open emo_ee26 Copy and past as new layer. Move down a bit.**
Open Tube and place to where it looks like it is coming
out of the emo_ee26. You may need to resize a bit. Add drop shadow.
On the emo_ee26 selections all - float - defloat.
On the tube erase whats on bottom part Seletions none
then erase any over hang of the tube from bottom.

Open emo_ee37 copy and paste as new layer. Resize by 90%
Move to bottom layer and then up to the top just a bit.**

Open emo_ee2 copy and paste as new layer. Resize by 50%
Move to bottom left of the tube** add drop shadow.

Open emo_ee31 Copy and paste as new layer resize by 25%
and place just to the right of the cat. add drop shadow

Open emo_ee1 copy and paste as new layer. Resize by 50%
Image - flip horizontal place just beside the cat and under the star.**
add drop shadow.

Open emo_pp1 copy and paste as new layer. Move to bottem. Open your mask
Layers - New mask layer - from image choose the mask in the list hit ok
merge group.

I resized all layers by 96% to make it 575x575

Add proper/clear copyright and Lic.# (If Needed)
For the name I used colors from the tube with a stroke width of 3.
The image below is the settings for inner bevel of your name.
 Add drop shadow of 2, 4, 100, 8

This tutorial was written by Rebecca Townsley on 6/5/12.
Any similarity to any other tutorial is purely coincidental.
Any creations you make following this tutorial is yours
to do with as you please as long as there is no profit made.
This tutorial is not to be copied or passed around.

I would love to see your results!
If you would like them shown on my blog
Send them to with
PTU Emo Kisses Result in the subject line
Can't wait to check them out!


Post a Comment

Proud CT For

Looking to join a team soon