Wednesday, April 10, 2013
This tut was made using PSPx4.
And knowledge of PSPx4.
Supplies needed
Tube of choice. I used Camilla Drakenborg.
You need a license to use Her Work.
You can get it and her work at The PSP Project.
PTU kit Spring Renewal by Whispys Dzines.
Mask MB and SW timeline mask 6 from Moonbeams and Spiderwebs.
Font of choice. I used PassionsConflictROB.
Go ahead and open list of Things here used and go ahead and resize them
by the percentage by each item. If there is no number no need to resize.
tube - 90%
tube reg
MB and SW Timeline Mask 6
wd_sr_pp8
wd_sr_pp4
wd_sr_el18 - 50%
wd_sr_el38 - 10%
wd_sr_el33 - 35%
wd_sr_el27 - 20%
When you see ** look at tag to see placement for Elements.
Sometimes it is hard to say just how to place it.
Drop shadows added are 0.0.75.7 unless otherwise stated.
It is always good to check for overhang of shadow on edges of tag.
I have made a tag or to and not check and when I got done
I would post it and see the over hang on the sides and think MAN!! lol
Remember to save often.
Open new Image 851x315.
Flood fill using wd_sr_pp8 as a pattern.
Layers new layerFlood. Flood fill using wd_sr_pp4
as a pattern. Open mask, Layers New mask layer,
find the mask in the list, click ok, merge group. Merge down.
Copy and paste wd_sr_el18 as new layer. Add drop shadow.
Copy and paste tube as new layer. Move to right of tag.**
Add drop shadow.
Now without resizing copy and paste tube as new layer.
Move to left of tag where only part of her shows.**
Blend mode, Luminance (L) Duplicate Blend mode hard light.
Add drop shadow to first Luminace layer tube.
Copy and paste wd_sr_el38 as new layer. Move to bottom
and just a bit to the right of center.** Add drop shadow.
Duplicate Image Flip Horizontal and Vertical. Move up
and to left of center. Tips of center leaf should touch.
Copy and paste wd_sr_el33 as new layer. Move to bottom of
tag.** Add drop shadow.
Copy and paste wd_sr_el27 as new layer.
Move to over top center leaf. Add drop shadow.
Duplicate free rotate to left 90 degrees.
Add proper copyright. url and Lic if required.
Add Saying Inner Bevel, Settings - Bevel 2, width 31
Smoothness 40, Depth 26, Ambience 37, Shineness 20
color (your choice I used a lighter color used on font),
Angle 0, Intensity 26, Elevations 90.
Duplicate Move top layer just a tad up to left.
On bottom saying layer Effects cutout, settings to your liking.
Add drop shadow settings 2.2.100.6.
Add name Inner bevel same settings as above.
Add drop shadow.
This tutorial was written by Rebecca Townsley on 4/10/13.
Any similarity to any other tutorial is purely coincidental.
Any creations you make following this tutorial is yours
to do with as you please as long as there is no profit made.
This tutorial is not to be copied or passed around.
I would love to see your results!
If you would like them shown on my blog
Send them to dragonsfairy_25@hotmail.com with
PTU Spring has Come in the subject line
Can't wait to check them out!
Subscribe to:
Post Comments
(Atom)
0 comments:
Post a Comment